[SIPForum-discussion] Would the fax call fail if there is a mistmatch between SDP Attributes
mustafa aydin
mustafaydin82 at yahoo.com
Wed Aug 25 07:29:19 UTC 2010
Hi Maciej,
Receiving gw is advertising udptl as per the section from the re-invite message
below;
Media Description, name and address (m): image 52392 udptl t38
Media Type: image
Media Port: 52392
Media Proto: udptl
Media Format: t38
I do not know the brands of gws which are involving to the scenario. But the
call is between PBX (emmiting side) and CO (receiving side).
Regards,
Mustafa Aydin
________________________________
From: Maciej Wasiel <Maciej.Wasiel at dialogic.com>
To: mustafa aydin <mustafaydin82 at yahoo.com>; "discussion at sipforum.org"
<discussion at sipforum.org>
Sent: Tue, August 24, 2010 10:47:25 PM
Subject: RE: [SIPForum-discussion] Would the fax call fail if there is a
mistmatch between SDP Attributes
Hi Mustafa,
Is the receiving gateway advertising tcp and udptl? Btw, do you know which
gateways are used in this call?
Maciej
From:discussion-bounces at sipforum.org [mailto:discussion-bounces at sipforum.org] On
Behalf Of mustafa aydin
Sent: Tuesday, August 24, 2010 8:28 AM
To: discussion at sipforum.org
Subject: [SIPForum-discussion] Would the fax call fail if there is a mistmatch
between SDP Attributes
Hello Guys,
In my scenario, the receiving gateway sends a reinvite (to negotiate t38) with
the following SDP attributes;
Media Attribute (a): T38FaxVersion:0
Media Attribute (a): T38FaxMaxBuffer:1100
Media Attribute (a): T38FaxMaxDatagram:612
Media Attribute (a): T38MaxBitRate:14400
Media Attribute (a): T38FaxRateManagement:transferredTCF
Media Attribute (a): T38FaxUdpEC:t38UDPRedundancy
However, the emitting gateway responds only with the attributes below in 200
OK;
Media Attribute (a): T38FaxRateManagement:transferredTCF
Media Attribute (a): T38MaxBitRate:14400
Then the recieving gateway sends another reinvite with removing the
"T38FaxUdpEC:t38UDPRedundancy" attribute, but this time the emitting gw responds
with a 200 which has "0" at it`s image port.
My questions are; whether the mismatch between these attributes is a reason for
a failure ? If so, should not the emitting gw respond back with a failure
message instead of a 200 OK ?
"draft-mule-sip-t38callflows-02.txt" indicates that only T38FaxMaxBuffer and
T38FaxMaxDatagram are optional, does it mean that all other attributes must
reside at the SDP ?
Best Regards,
Mustafa Aydin
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://sipforum.org/pipermail/discussion/attachments/20100825/895e0bf5/attachment-0002.html>
More information about the discussion
mailing list