[SIPForum-discussion] FAX Issue in VoIP

[Brent Shaw]

The errors that you list make it look like you are not even getting a
successful connection/negotiation. Do you actually connect, and then the
failure occurs during transmission? If so, you might want to check the
following settings:

 

t38 max-bps rate <value>

t38 max-buffer size (Had to adjust from default 200, to 262)
t38 max-datagram (Had to adjust from default 72, to 176)

 

Check the SDP offer when the T.38 session is initiated. 


Your default values may be different 

 

Brent 

 

From: discussion-bounces at sipforum.org
[mailto:discussion-bounces at sipforum.org] On Behalf Of murali shankar
Sent: Wednesday, September 08, 2010 8:28 PM
To: discussion at sipforum.org
Subject: [SIPForum-discussion] FAX Issue in VoIP

 

Dear All,

 

            Whenever am trying to send multiple pages in FAX over VoIP
at a single attempt the FAX is getting failed .Whereas for the same
number the FAX is going fine for single Paper.Can any one help me out?

 

Voip Gateway: Free Switch PBX.

Protocol: T.38

Codec: G.729A & G.711U

Baud rate: 9000 to 14400

 

Errors:

1. Busy Signal Detected.

2.No response to pps repeated 3 times.

3.Failed to train remote modem at 2400 BPS or minimum speed.

 

 

Please suggest.

 

Regards,

Murali

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://sipforum.org/pipermail/discussion/attachments/20100909/5d29f5c0/attachment-0002.html>