[SIPForum-discussion] CISCO 7940 TFTP Timeout

[Ian Sivell]

Hi,

I hope someone can help me

I have recently bought a used 7940 from EBay, initially it booted and I
could get into the menus (all be them locked), I found on the cisco site to
hold down th # key whilst powering up and then enter 123456789*0# to reset
toi factory defaults.

Since doing is the phone boots but just stays at the tftp timeout message.

On the Cisco site it says that the phone should timeout after 20 seconds and
continue to boot correctly after that giving access to the menus mine does
not seem to do this.

It has been loaded with SCCP (Skinny) as far as I can tell, and the DHCP
server on my network is assigning it a DHCP address within a valid subnet
but still it times out and does not get any further than the message above.

I have reset this several times to n avail

Please some one help me

Thanks
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://sipforum.org/pipermail/discussion/attachments/20071003/eafd44f7/attachment-0002.html>